After making the Fire Flower, I was asked if I was going to make the Piranha Plant. So I did. In the process of making the plant I realized it would be too easy to make it a Piranha Kirby, so why not.
These were printed on both the Prusa I3 MK3S and ProjectR3d Railcore II 300 ZL at .2mm layer height.
Multiple filaments were used.
Print Settings and orientation:
There are 2 ways to print the Piranha Plant, There is the version that has the head teeth, and lips all one one file which would be easier to print but the supports are harder to remove.
The second version has the lips and teeth and one file and the head separate. Makes for a nicer print at the end.
Piranha Kirby should be printed with supports from the bed.
Support me on Patreon:Become a Patron!
Follow me on Social Media:
Or if you would like to donate via Paypal: