Star Trek Transporter Diorama

This is a Diorama I made to show of the Star Trek Minis created by Wekster
The minis are not included in the Diorama
The inside is hollow and there are channels/tunnels built in for wiring up LED’s to make the individual pads and back panels light up.

Print Details:
This was printed on both my printers a Prusa I3 MK3S and a ProjectR3d Railcore II 300 ZL at .2mm layer height.

Print Settings and orientation:
The only part that needs support are the back panels and those I printed upside down to use as little support as possible.
The base is included as a single piece or split down the middle so it can fit most printers.



My Mini Factory:

Cults 3D:

Follow me on Social Media:

Support me on Patreon:

Become a Patron!

Or if you would like to donate via Paypal:

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: